Hyundai Accent: Opening the trunk
Fourth generation RB (2010–present) / Hyundai Accent 2010-2019 Owners Manual / Features of your vehicle / Trunk / Opening the trunk
- Press the trunk unlock button for more than 1 second on the transmitter (if equipped).
- Insert the master key into the lock and turn it clockwise.
- To open the trunk from inside the vehicle, pull the trunk lid release switch. Once the trunk is opened and then closed, the trunk is locked automatically.
NOTICE
In cold and wet climates, trunk locks and trunk mechanisms may not work properly due to freezing conditions.
WARNING
The trunk swings upward. Make sure no objects or people are near the rear of the vehicle when opening the trunk.
CAUTION
Make certain that you close the trunk before driving your vehicle. Possible damage may occur to the trunk lift cylinders and attached hardware if the trunk is not closed prior to driving.
Trunk
...
Closing the trunk
To close the trunk, lower the trunk lid, then press down on it until it locks.
To be sure the trunk lid is securely fastened, always check by trying to pull it
up again.
WARNING
The trunk lid s ...
See also:
Reassembly
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boots.
2.
Apply grease to the joint boot on the side of the wheel an ...
Schematic Diagrams
Circuit Diagram
...
Installation
Multifunction Switch
1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the stee ...