Hyundai Accent Manuals

Hyundai Accent: Reassembly - Front Driveshaft. Repair procedures - Driveshaft Assembly - Driveshaft and axleHyundai Accent: Reassembly

1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to the boots.
2.
Apply grease to the joint boot on the side of the wheel and install the boot.
3.
Install the clamp.

4.
Assemble the transaxle side joint boot and bands.
5.
Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and snap ring (B) on the driveshaft splines (C).

6.
Add specified grease to the joint boot as much as it was wiped away at inspection.
7.
Install the both boot band.
8.
To control the air in the TJ boot, keep the specified distance between the boot bands when they are tightened.
Engine
TM
Distance (L) mm (in.)
LH
RH
Gasoine 1.6 GDI
AT
488.9 (19.24)
780.7 (30.74)
MT
512.1 (20.16)
792.5 (31.20)

9.
Using the SST (09495-3K000), secure the TJ boot band.


Disassembly
• Do not disassemble the BJ assembly. • Speci ...

Rear Axle Assembly
...

See also:

Economical operation
Your vehicle's fuel economy depends mainly on your style of driving, where you drive and when you drive. Each of these factors affects how many miles (kilometers) you can get from a gallon (l ...

Description and Operation
Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are pre-programmed ...

Components and Components Location
Components Location 1. Fuel Tank 2. Fuel Pump 3. Fuel Filter 4. Fuel Pressure Regulator 5. Canister 6. Fuel Tank Band 7. Fuel Filler Hose 8. Ventilatio ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com