Hyundai Accent: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Lift the vehicle.
|
| 3. |
Disconnect the canister close valve connector (A).
|
| 4. |
Disconnect the ventilation hose (B) from the fuel
tank air filter and canister close valve.
|
| 5. |
Remove the fuel tank air filter assembly after removing
a bolt (A).
|
| 6. |
Remove the bracket (A) after pulling it.
|
| 7. |
Release the lever (A), and then separate the canister
close valve (B) from the fuel tank air filter (C) after rotating it
in the direction of the arrow in the figure.
|
Installation
•
Install the component with the specified
torques.
...
See also:
Description and Operation
Description
Ignition timing is controlled by the electronic control ignition
timing system. The standard reference ignition timing data for the engine operating
conditions are pre-programmed ...
Inspection
Armature
1.
Remove the starter.
2.
Disassemble the starter as shown at the beginning
of this procedure.
3 ...
Manifold Absolute Pressure
Sensor (MAPS). Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com