Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Depowered) / Airbag Module / Passenger Airbag (PAB) Module. Repair procedures / Removal

1.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

2.	Remove the glove box housing. (Refer to the Body group - "Crash pad")

3.	Disconnect the passenger airbag connector (A) and remove the PAB mounting bolt (B).

4.

Remove the crash pad.

(Refer to the Body group - "Crash pad")

Replace the crash pad which is damaged while PAB is deployed.

5.

Remove the mounting bolts from the crash pad. Then remove the passenger airbag.

The removed airbag module should be stored in a clean, dry place with the airbag cushion up.

Passenger Airbag (PAB) Module. Repair procedures

...

Installation

1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least three minutes befo ...

See also:

Intake Air Temperature Sensor (IATS). Description and Operation
Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction o ...

Speed sensing door lock system
All doors will be automatically locked after the vehicle speed exceeds 9 mph (15 km/h). And all doors will be automatically unlocked when you turn the engine off or when you remove the ignition ke ...

Components and Components Location
Components 1. HECU module 2. Front wheel speed sensor 3. Rear wheel speed sensor 4. Yaw rate & Lateral G sensor 5. Steering angle sensor 6. ABS Warning l ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com