Hyundai Accent Manuals

Hyundai Accent: Replacement - Hood. Repair procedures - Exterior - Body (Interior and Exterior)Hyundai Accent: Replacement

Hyundai Accent RB (2010-2018) Service Manual / Body (Interior and Exterior) / Exterior / Hood. Repair procedures / Replacement

Hood Assembly Replacement
•
When removing and installing the hood, an assistant is necessary.
•
Take care not to damaged the hood and body.
1.
After loosening the hood hinge (A) mounting bolts, and then remove the hood (B).
Tightening torque :
21.6 ~ 26.5 Nm (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft)

2.
Installation is the reverse of removal.
•
Make sure the hood opens properly and locks securely.
•
Adjust the hood alignment.
Hood Insulator Pad Replacement
1.
Using a clip remover, detach the clips, and remove the hood insulator pad (A).
•
Be careful not to scratch the hood panel.

2.
Installation is the reverse of removal.
•
Replace any damaged clips.
Hood Weatherstrip Replacement
1.
Remove the hood weatherstrip(A).
2.
Installation is the reverse of removal.
Hood Release Handle Replacement
1.
Disconnect the hood release handle cable (B).
2.
After loosening the mounting screws, then remove the hood release handle (A).
3.
Installation is the reverse of removal.
•
Make sure the hood latch cable is connected properly.
•
Make sure the hood locks securely.
Hood Latch Replacement
1.
Remove the hood latch (A) mounting bolts.
Tightening torque :
6.9 ~ 10.8 Nm (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

2.
Disconnect the hood latch cable (A), and then remove the latch (B).

3.
Installation is the reverse of removal.
•
Make sure the hood latch cable is connected properly.
•
Make sure the hood locks securely.

Hood. Repair procedures
...

Adjustment
Hood Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up or down, or right or left. 2. Adju ...

See also:

Clutch Master Cylinder. Components and Components Location
Components 1. Reverse hose 2. Master cylinder 3. Clutch switch 4. Ignition lock switch 5. Pedal pad ...

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between ...

To temporarily accelerate with the cruise control on
If you want to speed up temporarily when the cruise control is on, depress the accelerator pedal. Increased speed will not interfere with cruise control operation or change the set speed. To retu ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com