Hyundai Accent: Seat Belt Buckle Switch (BS). Description and Operation

The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ground for the signal return. The buckle status shall modify the SRSCM deployment. If the buckle status is unbuckled, the corresponding pretensioner will not be deactivated.

Installation

Pressure Side Impact Sensor 1. Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A). ...

Seat Belt Buckle Switch (BS). Components and Components Location

Components ...

See also:

Front Hub / Knuckle. Components and Components Location
Components 1. Snap ring 2. Bearing 3. Axle assembly 4. Brake disc dust cover 5. Wheel hub assembly 6. Wheel brake disc 7. Brake disc fixing screw 8. Wh ...

Troubleshooting
Troubleshooting Symptom Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Loose or improperly installed e ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ...