Hyundai Accent Manuals

Hyundai Accent: Inspection - Brake Pedal. Repair procedures - Brake System - Brake SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Brake System / Brake System / Brake Pedal. Repair procedures / Inspection

1.
Check the bushing for wear.
2.
Check the brake pedal for bending or twisting.
3.
Check the brake pedal return spring for damage.
4.
Check the stop lamp switch.
(1)
Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in and when it is released.
(2)
The stop lamp switch is in good condition if there is no continuity when plunger (A) is pushed.

Removal
1. Turn ignition switch OFF. 2. Remove the crash pad lower panel. (Refer to the Body group - "Crash pad") ...

Installation
1. Installation is the reverse of removal. • ...

See also:

Installation
1. Install the washer reservoir. Before installing the pump motor, check the f ...

ETC (Electronic Throttle Control) System. Troubleshooting
Fail-Safe Mode Item Fail-Safe ETC Motor Throttle valve stuck at 7° TPS TPS 1 fault ECM looks at TPS2 ...

How vehicle audio works
FM radio reception AM and FM radio signals are broadcast from transmitter towers located around your city. They are intercepted by the radio antenna on your vehicle. This signal is then receive ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com