Hyundai Accent Manuals

Hyundai Accent: Replacement - Sunroof. Repair procedures - Exterior - Body (Interior and Exterior)Hyundai Accent: Replacement

Hyundai Accent RB (2010-2018) Service Manual / Body (Interior and Exterior) / Exterior / Sunroof. Repair procedures / Replacement

Glass Replacement
•
Put on glove to protect your hands.
1.
Remove the glass (A) by lifting it up.
•
Do not damage the roof panel.

2.
Installation is the reverse of removal.
Motor Replacement
1.
Remove the roof trim.
(Refer to the BD group - "Roof Trim")
2.
Disconnect the connector (B).
3.
Remove the motor after removing screws from the motor (A).
4.
Installation is the reverse of removal.
•
Make sure to initilize the motor.
Deflector Replacement
1.
Open the glass fully.
2.
Disconnect the deflector link (A) from the frame (B), and then remove the deflector (C).
3.
Installation is the reverse of removal.
Sunroof Assembly Replacement
1.
Remove the follows parts.
A.
Front seat
(Refer to the BD group - "Front Seat")
B.
Rear seat
(Refer to the BD group - "Rear Seat")
C.
Interior trim
(Refer to the BD group - "Interior Trim")
D.
Roof trim
(Refer to the BD group - "Roof Trim")
2.
After loosening the mounting bolts, then remove the assist handle bracket
3.
Disconnect the drain tubes (B).
4.
After loosening the mounding nuts, remove the sunroof assembly (A).
Tightening torque :
3.9~5.9 N.m (0.4~0.6 kgf.m, 2.9~4.3 lb-ft)

5.
Installation is the reverse of removal.
Sunshade And Drip Rail Replacement
1.
Remove the sunroof assembly.
2.
Remove the drip link (A) and sunshade stopper (B).
3.
Remove the sunshade (C) and drip rail (D).
4.
Installation is the reverse of removal.
Guide Assembly Replacement
1.
Remove the sunroof assembly.
2.
Remove a guide assembly (A) after lowering a guide thoroughly by pushing a slide to rear.
3.
Remove the guide (A) and slide (B).
4.
Installation is the reverse of removal.
•
Make sure to align the slide with the center of “A” and “B”
•
Make sure to initialize the motor.

Sunroof. Repair procedures
...

Adjustment
How To Initialize Motor 1. Check that the glass has been installed. A. Finished height adjustment. 2. ...

See also:

Brake Booster. Components and Components Location
Components 1. Brake booster 2. Master cylinder assembly 3. O-ring ...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes. ...

Installation
• Install the component with the specified torques. • ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com