Hyundai Accent: Inspection
| 1. |
Check that the red light flickers when the door lock or unlock
button is pressed on the transmitter.
|
| 2. |
Remove the battery and check voltage if the red light doesn't
flicker.
|
| 3. |
Insert the battery (A) into the tester (09954-2p100).
|
| 4. |
Push the test button and If "0.00" is displayed on screen, it
means that the battery voltage is 2V or less.
|
| 5. |
If "L" is displayed on screen, it means that the battery is low
power and it needs to replace.
|
| 6. |
To prevent the discharge of electricity, turn the tester power
off.
|
| 7. |
Replace the transmitter battery with a new one, if voltage is
low power then try to lock and unlock the doors with the transmitter
by pressing the lock or unlock button five or six times.
|
| 8. |
If the doors lock and unlock, the transmitter is O.K, but if the
doors don't lock and unlock, register the transmitter code, then try
to lock and unlock the doors.
|
| 9. |
If the doors lock and unlock, the transmitter is O.K, but if the
doors don't lock and unlock, replace the transmitter.
|
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...
See also:
General Safety Information and
Caution
Precautions
General Precautions
Please read the following precautions carefully before performing the
airbag system service.
Observe the instructions described in this manual, ...
Wheel. Repair procedures
Hub Nut Tightening Sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Components and Components Location
Components
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com