Hyundai Accent: Wheel. Repair procedures
Hyundai Accent RB (2010-2018) Service Manual / Suspension System / Tires/Wheels / Wheel. Repair procedures
Hub Nut Tightening Sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
|
When using an impact gun, final tightening torque should be checked
using a torque wrench.
|
Rear Wheel Alignment
When using a commercially available computerized wheel alignment
equipment to inspect the rear wheel alignment, always position ...
Tire. Repair procedures
•
Using tires and wheel other than the recommended sizes
could cause unusual handling charact ...
See also:
Checking the brake/clutch fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir cap and adding brake/clutch fl ...
Removal
1.
Turn ignition switch OFF.
2.
Disconnect the brake fluid level switch connector (A) from the
reservoir.
3.
...
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of
...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com