1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the lighting switch of the multi-function switch. (Refer
to the multifunction switch)
|
3. |
With the front fog lamp switch, make sure that continuity exists
between the terminals below.
If continuity is not as specified, replace the multi-function
switch.
|
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop it. If the
pedal depresses ...
Yaw-rate and G Sensor. Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the front seat (LH) assembly.
(Refer ...
Instrument panel illumination
When the vehicle’s parking lights or headlights are on, press the upper or lower
part of the switch to adjust the brightness of the instrument panel illumination. ...