Hyundai Accent Manuals

Hyundai Accent: Inspection - Timing Chain. Repair procedures - Timing System. - Engine Mechanical SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Engine Mechanical System / Timing System. / Timing Chain. Repair procedures / Inspection

Sprockets, Hydraulic Tensioner, Chain Guide, Tensioner Arm
1.
Check the CVVT sprocket, crankshaft sprocket teeth for abnormal wear, cracks or damage. Replace if necessary.
2.
Check a contact surface of the chain tensioner arm and guide for abnormal wear, cracks or damage. Replace if necessary.
3.
Check the hydraulic tensioner for its piston stroke and ratchet operation. Replace if necessary.
Belt, Idler, Pulley
1.
Check the idler for excessive oil leakage, abnormal rotation or vibration. Replace if necssery.
2.
Check belt for maintenance and abnormal wear of V-ribbed part. Replace if necssery.
3.
Check the pulleys for vibration in rotation, oil or dust deposit of V-ribbed part. Replace if necssery.
•
Do not bend, twist or turn the timing belt inside out.
•
Do not allow the timing belt to come into contact with oil, water and steam.

Removal
Engine removal is not required for this procedure. • Use fender covers to avoid damaging painted ...

Installation
1. Dowel pin of crankshaft should be positioned at 3° in relation to vertical center line. 2. Align the TDC marks (A) of the CVVT ...

See also:

Good braking practices
WARNING Whenever you leave or park your vehicle, always set the parking brake as far as possible and fully engage the vehicle's transaxle into the P (Park) position. If the parking brak ...

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between ...

PODS-F Zeroing procedure
You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly) 1. Ignition “OFF” ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com