1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the lighting switch of the multi-function switch. (Refer
to the multifunction switch)
|
3. |
With the front fog lamp switch, make sure that continuity exists
between the terminals below.
If continuity is not as specified, replace the multi-function
switch.
|
Anchor Pretensioner (APT). Description and Operation
Description
Front anchor pretensioner operates as well as Belt Pretensioner at the
same time If it gets into its deploy condition after a collision. It is located
at near anchor on driver se ...
Installation
1.
Installation is the reverse of removal.
A.
...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes.
...