Hyundai Accent Manuals

Hyundai Accent: Specifications - General Information - Engine Electrical SystemHyundai Accent: Specifications

Specifications

Ignition System
Items
Specification
Ignition coil
Primary resistance
0.7 ± 15 % (Ω)
Secondary resistance
5.9 (kΩ)
Spark plugs
Type
SILZKR6B10E
Gap
1.0 ~ 1.1 mm (0.0394 ~ 0.0433in.)

Starting System
Items
Specification
Starter
Rated voltage
12V, 0.9kW
No. of pinion teeth
8
No-load characteristics
Voltage
11.5V
Ampere
60A, MAX
Speed
5,500rpm, MIN

Charging System
Items
Specification
Alternator
Rated voltage
13.5V, 90A
Speed in use
1,000 ~ 18,000rpm
Voltage regulator
IC Regulator built-in type
Regulator setting voltage
External mode
ECU control
Internal mode
 14.55 ± 0.3V
Temperature compensation
External mode
ECU control
Internal mode
-3.5 ± 2mV / °C
Battery
Type
36 - 20 GL
Cold cranking amperage
410A
[at -18°C (-0.4°F)]
Reserve capacity
80min
Specific gravity [at 25°C(77°F)]
1.280 ± 0.01

•
COLD CRANKING AMPERAGE is the amperage a battery can deliver for 30 seconds and maintain a terminal voltage of 7.2V or greater at a specified temperature.
•
RESERVE CAPACITY RATING is amount of time a battery can deliver 25A and maintain a minimum terminal voltage of 10.5V at 26.7°C(80.1°F).


General Information
...

Troubleshooting
Troubleshooting Starting System Symptom Suspect area Remedy Engine will not crank Battery charge low Charge or replace batt ...

See also:

Adjustment
Glass Adjustment • Check the glass run channel for damage or deterioration, and replace ...

Crankshaft Position Sensor (CKPS). Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the eng ...

Installation
1. Place the thermostat in the block. Install the thermostat (B) with the jiggle valve upward. 2. Install the water inlet fitting ( ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com