Inspection
1. |
After disconnecting the vapor hose from the PCV valve,
remove the PCV valve.
|
2. |
Reconnect the PCV valve to the vapor hose.
|
3. |
Run the engine at idle, then put a finger over the
open end of the PCV valve and make sure that intake manifold vacuum
can be felt.
|
4. |
If the vacuum is not felt inspect PCV operation,
if operating correctly clean or replace the vapor hose.
|
Removal
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airbag.
...
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) fro ...
ECM Terminal And Input/Output signal [A/T]
ECM Terminal Function
(A/T)
Connector [EGGA-AG]
Pin No.
Description
Connected to
1
Injector (Cylinder #1) [High] ...