Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S). Repair procedures / Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.

Disconnect the connector (A), and then remove the sensor (B).

Note that the SST (Part No.: 09392-2H100) is useful when removing the heated oxygen sensor.

[Bank 1 / Sensor 1]

[Bank 1 / Sensor 2]

Inspection

1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S termi ...

Installation

• Install the component with the specified torques. • ...

See also:

Line Pressure Control Solenoid Valve. Specifications
Specifications Direct control VFS[LINE Pressure] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.4 ~ 0.1, 7.6 ...

Front Body D ( 5Door )
Hood hinge mounting hole (Ø10) Fender apron upper member tooling hole (Ø6.6) Front shock ...

Installation
1. Installation is the reverse of removal. • ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com