Hyundai Accent Manuals

Hyundai Accent: Installation - Variable Intake Solenoid (VIS) Valve. Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve. Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Use care to keep foreign material out of the valve.
1.
Installation is reverse of removal.

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ...

Fuel Pressure Control Valve. Description and Operation
Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on ...

See also:

Steering Gear box. Components and Components Location
Components 1. Tie-rod end 2. Lock nut 3. Bellows clip 4. Bellows 5. Tie rod 6. Rack bar 7. Dust packing 8. Dust cap 9. Oil seal 10. Pinion plug ...

Removal
1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Automatic Transaxle. Components and Components Location
Components Location 1. Converter housing 2. Shift cable bracket 3. Automatic transaxle case 4. Rear cover 5. Valve body cover 6. Manual control lever 7. A ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com