Inspection
1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Disconnect the fuel pressure regulator valve connector.
|
3. |
Measure resistance between the fuel pressure regulator
valve terminals 1 and 2.
|
4. |
Check that the resistance is within the specification.
|
Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located in the driver’s side panel bolster,
the other in the engine ...
Inside rearview mirror
Adjust the rearview mirror so that the center view through the rear window is
seen. Make this adjustment before you start driving.
WARNING - Rear visibility
Do not place objects in the rear seat ...
Hazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the road as far as po ...