Hyundai Accent: Removal
| 1. |
Release the residual pressure in fuel line (Refer
to “Release Residual Pressure in Fuel Line” in this group).
|
| 2. |
Remove the rear seat [LH] (Refer to “Seat” in BD
group).
|
| 3. |
Remove the fuel pump service cover (A).
|
| 4. |
Disconnect the fuel pump connector (A).
|
| 5. |
Disconnect the fuel feed tube quick connector (B).
|
| 6. |
Disconnect the fuel tank pressure sensor connector
(C).
|
| 7. |
Disconnect the vapor tube (D).
|
| 8. |
Lift the vehicle and support the fuel tank with a
jack.
|
| 9. |
Remove the center muffler assembly (Refer to “Intake
And Exhaust System” in EM group).
|
| 10. |
Disconnect the fuel filler hose (A) and the vapor
hose (B).
|
| 11. |
Remove the parking brake line installation bolt (A).
|
| 12. |
Remove the fuel tank from the vehicle after removing
the fuel tank band (A).
|
Installation
1.
Installation is reverse of removal.
Fuel tank band
installation nut:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~
39.8 lb-ft ...
See also:
Removal
1.
Remove the rear roof trim.
(Refer to the Body group - Roof trim).
2.
Disconnect the antenna cable (A).
3 ...
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...
Interior light
CAUTION
Do not use the interior lights for extended periods when the engine is
not running. It may cause battery discharge.
WARNING
Do not use the interior lights when driving in the dark. Accide ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com