Components Location
1. Injection hole(eyebolt) 2. Oil level plug 3. Oil drain plug |
Oil Pressure Switch. Repair
procedures
Inspection
1.
Check the continuity between the terminal and the
body with an ohmmeter. If there is no continuity, replace the oil pressure
switch.
...
Reassembly
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boots.
2.
Apply grease to the joint boot on the side of the wheel an ...
Replacement
1.
Disconnect the battery negative cable from the battery and then
wait for at least 30 seconds.
2.
Turn the steering wheel so that the fro ...