Hyundai Accent Manuals

Hyundai Accent: Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Repair procedures

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Repair procedures

Adjustment

TCM Learning
When shift shock is occurred or parts related with the transaxle are replaced, TCM learning should be performed.
In the following case, TCM learning is required.
•
Transaxle assembly replacement
•
TCM replacement
•
TCM upgrading
1.
TCM learning condition
A.
ATF temperature: 40 ~ 90°C (104 ~ 194°F)
2.
TCM learning procedure
A.
Stop learning
Repeat the below shift pattern four times or more with stepping on the brake.
B.
Driving learning
1.
Drive the vehicle through all gears at D range. Drive from stop to 1st to 2nd to 3rd to 4th to 5th to 6th with keeping fixed throttle open.
2.
Down shift from 6th to 5th, 5th to 4th, 4th to 3rd, 3rd to 2nd, 2nd to 1st.
3.
Repeat the above driving pattern four times or more.
Up-shift throttle open : 15 ~ 25%

Control System Composition
Fault Diagnosis Features a fail-safe mechanism that prevents dangerous situations from developing in the event of a transaxle failure. The limp home mode engages if the transaxle mal ...

Schematic Diagrams
Circuit Diagram ...

See also:

Storage compartments
These compartments can be used to store small items. CAUTION To avoid possible theft, do not leave valuables in the storage compartments. Always keep the storage compartment covers closed whil ...

Rear Door. Components and Components Location
Components 1. Rear door trim 2. Rear door seal 3. Rear door panel 4. Rear door delta inner cover 5. Rear door channel 6. Rear door belt inside weatherstrip 7. ...

Installation
1. Reassemble the hands free switch after connecting the connector. 2. Reassemble the steering wheel. 3. Reasse ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com