Hyundai Accent: Removal
| 1. |
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
|
| 2. |
Remove the under cover (A).
|
| 3. |
Replace new gasket and the plug after draining the automatic transaxle
fluid by removing the drain plug.
(Refer to "Hydraulic system (Fluid)" in this group)
|
| 4. |
Remove the air breeder hose (A).
|
| 5. |
Remove the valve body cover (B).
|
| 6. |
Remove the bolt (3ea) after disconnecting the solenoid valve connector
(B) and the oil temperature sensor connector (A).
|
| 7. |
Remove the solenoid valve support bracket (B) and the valve body
mounting bolt (A-1ea).
|
| 8. |
Remove the torque converter control solenoid valve (A).
|
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Installation
1.
Installation is the reverse of removal.
•
...
See also:
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Checking the tire inflation pressure
1.After driving approximately 4~6miles (7~10km or about 10min), stop at a safety
location.
2.Connect connection hose (9) of the compressor directly to the tire valve.
3.Plug the compressor power c ...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes.
...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com