1. |
Turn ignition switch OFF.
|
2. |
Disconnect the oil temperature sensor connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
|
Rear Glass Defogger Printed Heater. Repair procedures
Inspection
Wrap tin foil around the end of the voltmeter test lead to prevent
damaging the heater line. Apply finger pressure ...
Interior Trim. Components and Components
Location
Components
1. Front pillar trim
2. Center pillar lower trim
3. Center pillar upper trim
4. Rear pillar trim [4 Door]
5. Rear wheelhousing trim
6. Front door scuf ...
Repair procedures
On-vehicle Inspection
Spark Test
1.
Disconnect the connectors (A) and then ignition coils
(B).
2.
Disconnect ...