Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / SS-B Solenoid Valve(ON/OFF). Repair procedures / Installation

1.

Installation is the reverse of removal.

•	The gasket of the valve body cover gasket (A) use new one.

•	Adding automatic transaxle fluid. (Refer to "Hydraulic system (Fluid)" in this group)

•	Perform TCM learning after replacing the automatic transaxle to prevent slow automatic transaxle response, jerky acceleration and jerky startup. (Refer to "Automatic transaxle control system (Repair procedures)" in this group)

Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraul ...

Inhibitor Switch. Description and Operation

Description Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals. ...

See also:

Manual heating and air conditioning
The heating and cooling system can be controlled manually by pushing buttons other than the AUTO button. In this case, the system works sequentially according to the order of buttons selected. Wh ...

Rear combination light bulb replacement (4 Door)
(1) Stop and tail light (2) Rear turn signal light (3) Back-up light (4) Side marker 1. Open the trunk lid. 2. Remove the service cover by pulling out the service cover. 3. Remove the sock ...

Installation
1. Install the wiper motor. 2. Install the crank arm. 3. Install the lower and upper linkage to the wiper motor ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com