Hyundai Accent: Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
| 1. |
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
|
| 2. |
Remove the under cover (A).
|
| 3. |
Replace new gasket and the plug after draining the automatic transaxle
fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)"
in this group)
|
| 4. |
Remove the valve body cover (A) and eyebolt (B).
|
| 5. |
Remove the bolt (3ea) after disconnecting the solenoid valve connector
(B) and the oil temperature sensor connector (A).
|
| 6. |
Remove the solenoid valve (B) after removing the solenoid support
(A).
|
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Installation
1.
Installation is the reverse of removal.
•
...
See also:
Engine Coolant Temperature
Sensor (ECTS). Description and Operation
Description
Engine Coolant Temperature Sensor (ECTS) is located in the
engine coolant passage of the cylinder head for detecting the engine coolant
temperature. The ECTS uses a thermistor th ...
Removing and storing the spare tire
Turn the tire hold-down wing bolt counterclockwise.
Store the tire in the reverse order of removal.
To prevent the spare tire and tools from “rattling” while the vehicle is in motion,
store ...
Control System Composition
Fault Diagnosis
Features a fail-safe mechanism that prevents dangerous situations from
developing in the event of a transaxle failure. The limp home mode engages if
the transaxle mal ...
Hyundai Accent Manuals
