Hyundai Accent: Adjustment
Adjusting the control cable
| 1. |
Set room side AT lever(shift lever) and automatic transaxle side
manual control lever to "N" position.
|
| 2. |
Connect control cable to room side AT lever(shift lever).
|
| 3. |
Fix temporary control cable (A) in automatic transaxle side manual
control lever.
|
| 4. |
Push the control cable (A) lightly to "F" direction shown to eliminate
the free play.
|
| 5. |
Tighten the adjusting nut (B).
|
Adjusting Procedure For Lock Cam And Shift Lock Cable
| 1. |
Shift lock cable must be fixed to brake pedal(brake pedal must
not be pressed down), and at lever(shift lever) must be "N" position.
|
| 2. |
Shift lock cable must be assembled to at lever(shift lever) assembly
as shown in fig. 1. cable end must be inserted into fixing pin (A) of
lock cam securely.
|
| 3. |
Maintain close adhesion lock cam (E) and lock cam stopper (D)
slightly pull outer casing of shift lock cable (E) in direction "E"
to remove slack of shift lock cable (E).
|
| 4. |
After checking that cable end is touched to cable fixing pin of
lock cam, fix adjust plate.
|
| 5. |
Check that cable end (B) is touched to cable fixing pin of lock
cam (A).
|
Checking List Of Shift Lock
| 1. |
Brake pedal being not depressed.
AT lever (shift lever) must not be shifted from "P" position to
"R" posion.
|
| 2. |
Brake pedal being not depressed.
AT lever (shift lever) must not be shifted from "N" position to
"R" posion.
|
| 3. |
Brake pedal being deprseeed by stroke 15-26mm in "P" position.
Push button can be operated and AT lever (shift lever) can be
shifted smoothly from each position to other positions.
|
| 4. |
Brake pedal must be operated smoothly without interruption at
all positions.
|
Removal
Shift Lever Assembly Replacement
1.
Remove the center console.
(Refer to "interior (console)" in BD group)
2.
Disconnec ...
See also:
Wheel replacement
When replacing the metal wheels for any reason, make sure the new wheels are
equivalent to the original factory units in diameter, rim width and offset.
WARNING
A wheel that is not the correct si ...
Passenger Airbag (PAB) Module. Description
and Operation
Description
The passenger airbag (PAB) is installed inside the crash pad and protects
the front passenger in the event of a frontal crash. The SRSCM determines if
and when to deploy the PAB. ...
Parking brake
Checking the parking brake
Check the stroke of the parking brake by counting the number of “clicks’’ heard
while fully applying it from the released position. Also, the parking brake alone ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com