Hyundai Accent: Driveshaft and axle

Adjustment

Adjusting the control cable 1. Set room side AT lever(shift lever) and automatic transaxle side manual control lever to "N" position. 2. ...

General Information

...

See also:

Components and Components Location
Component Location 1. Driver power window switch 2. Door lock switch 3. BCM (Body Control Module) 4. Front door lock actuator 5. Rear door lock actuator 6. I ...

Room Lamp. Repair procedures
Inspection Room Lamp 1. Check that the switch operates properly after disconnecting the room lamp connector (A). ...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least three minutes befo ...