The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as possible.
The hazard warning lights are turned on by pushing in the hazard switch. This causes all turn signal lights to blink. The hazard warning lights will operate even though the key is not in the ignition switch.
To turn the hazard warning lights off, push the switch a second time.
Transaxle Oil Temperature Sensor. Specifications
Specifications
▷ Type: Negative Thermal Coefficient Type
Temp.[(°C)°F]
Resistance (kΩ)
(-40)-40
48.1
(-20)-4.0 ...
Instrument panel illumination
When the vehicle’s parking lights or headlights are on, press the upper or lower
part of the switch to adjust the brightness of the instrument panel illumination. ...
Component(1)
<Installation order : A→B→C→D>
1. Steering column shaft
2. Lighting switch
3. Wiper and washer switch
4. Screw
5. Clock spring
...