1. |
Check the hub for cracks and the splines for wear.
|
2. |
Check the brake disc for scoring and damage.
|
3. |
Check the rear axle carrier for cracks
|
4. |
Check the bearing for cracks or damage.
|
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below ...
Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...