Hyundai Accent: Rear Wheel Alignment
Hyundai Accent RB (2010-2018) Service Manual / Suspension System / Tires/Wheels / Alignment. Repair procedures-Revised / Rear Wheel Alignment
When using a commercially available computerized wheel alignment
equipment to inspect the rear wheel alignment, always position the vehicle
on a level surface.
Prior to inspection, make sure that the rear suspension system
is in normal operating condition and that the tires are inflated to
the specified pressure.
|
Toe
B - A. 0: Toe in (+)
B - A < 0: Toe out (-)
|
Toe is pre-set at the factory, so it does not need to be adjusted. If
the toe is not within the standard value, replace or repair the damaged parts
and then inspect again.
Toe:
Total : 0.5° (+0.4°/ -0.5°)
Individual :0.25°(+0.2°/ -0.25°)
|
Camber
Camber is pre-set at the factory, so it does not need to be adjusted.
If the camber is not within the standard value, replace or repair the damaged
parts and then inspect again.
Camber : -1.5°±0.5°
|
Front Wheel Alignment
When using a commercially available computerized wheel alignment
equipment to inspect the front wheel alignment, always positio ...
Wheel. Repair procedures
Hub Nut Tightening Sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
See also:
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV termi ...
Components and Components Location
Component Location
1. Sunroof
2. Sunroof switch
3. Sunroof motor & controller
...
Installation
1.
Install the power window switch module.
2.
Install the door trim panel after reconnecting the relevant connectors
...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com