Hyundai Accent Manuals

Hyundai Accent: Installation - TPMS Sensor. Repair procedures - Tire Pressure Monitoring System - Suspension SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Sensor. Repair procedures / Installation

Sensor Fit
•
Handle the sensor with care.
•
Avoid lubricant contact.
•
Ensure that the wheel to be fitted is designed for sensor mount. There should normally be a mark to indicate this.
•
Ensure that the valve hole and mating face of the wheel are clean.
1.
Slide the sensor-valve unit through the valve hole of the rim. Hold the sensor against the rim and the rubber grommet against the sealing surface.
2.
Insert the nut over the valve stem and then tighten the nut.
3.
Continue to tightening the nut until contact with the rim and then tighten to 3.5 ~ 4.5Nm.

-
Tighten slowly with quarter turn steps until the final torque is reached.
-
Do not exceed allowed torque.
-
Do not use electric or pneumatic tools.
4.
Check that the sensor is firmly attached to the rim.
Risk of damage during the tire installation/ removal if the sensor is not firmly attached to the rim.
5.
Carry out inflation / pressure correction and then fit valve cap.
Change the newly installed sensor mode to Normal Fixed Base(Low Line) with the 'GDS'.
Mode (Status / option) of the sensor installed to the vehicle should be Normal Fixed Base (Low).
6.
Install the tire. (Refer to "Tire Installation")
Sensor ID Writing (Wireless)

Sensor ID Writing


Replacement
Repair tire after using the Tire Mobility Kit (TMK) When the TPMS warning lamp OFF 1. Remove the TMK repaired tire, wheel and TPMS sensor. (Refer ...

TPMS Receiver. Repair procedures
Replacement 1. Disconnect the battery negative cable from the battery. 2. Remove faulty part and fit bracket assembly to new part. ...

See also:

Installation
1. Install the bulb. 2. Connect the connector and install the trunk trim. ...

This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: 1.This device may not cause harmful interference, and 2.This device must accept any interference received, including interference that may cau ...

Automatic Transaxle. Components and Components Location
Components Location 1. Converter housing 2. Shift cable bracket 3. Automatic transaxle case 4. Rear cover 5. Valve body cover 6. Manual control lever 7. A ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com