Hyundai Accent Manuals

Hyundai Accent: Installation - Side Airbag (SAB) Module. Repair procedures - Airbag Module - Restraint (Depowered)Hyundai Accent: Installation

Be sure to install the harness wires not to be pinched or interfered with other parts.
•
Do not open the lid of the side airbag cover.
•
Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the new seat back assembly.
(Refer to the Body group - "Seat")
4.
Install the front seat assembly.
(Refer to the Body group - "Seat")
5.
Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfering with other parts.
6.
Reconnect the battery negative cable.
7.
After installing the side airbag (SAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag. ...

Curtain Airbag (CAB) Module. Description and Operation
Description Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain ...

See also:

Body Control Module (BCM). Specifications
Specifications Item Requirement Remark Rated voltage DC 12V Shall activate normally in these range. Operat ...

[CVVT System Mode]
(1) Low Speed / Low Load (2) Part Load (3) Low Speed / High Load (4) High Speed / High Load ...

Airbag Module Disposal. Description and Operation
Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbag ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com