1. |
Remove the snap ring (A).
|
2. |
Remove the hub assembly from the knuckle assembly.
|
3. |
Remove the hub bearing inner race from the hub assembly.
|
4. |
Remove the dust cover (A).
|
5. |
Remove the hub bearing outer race from the knuckle assembly.
|
6. |
Replace hub bearing with a new one.
|
Power Window Motor. Repair procedures
Inspection
Front Power Window Motor Inspection
1.
Remove the front door trim panel.
(Refer to the BD group - "Front door")
2.
...
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of
...
Service Standard
Item
Specification
Ignition Timing (°)
BTDC 3 ± 10
Idle Speed (rpm)
A/C OFF
Neutral, N, P-range
...