Rotor |
1. |
Check that there is continuity between the slip rings
(C).
|
2. |
Check that there is no continuity between the slip
rings and the rotor (B) or rotor shaft (A).
|
3. |
If the rotor fails either continuity check, replace
the alternator.
|
1. |
Check that there is continuity between each pair
of leads (A).
|
2. |
Check that there is no continuity between each lead
and the coil core.
|
3. |
If the coil fails either continuity check, replace
the alternator.
|
Installation
Side Impact Sensor
•
Do not turn the ignition switch ON and do not connect
the battery c ...
Rear combination light bulb replacement (4 Door)
(1) Stop and tail light
(2) Rear turn signal light
(3) Back-up light
(4) Side marker
1. Open the trunk lid.
2. Remove the service cover by pulling out the service cover.
3. Remove the sock ...
Description and Operation
Description
Ignition timing is controlled by the electronic control ignition
timing system. The standard reference ignition timing data for the engine operating
conditions are pre-programmed ...