Hyundai Accent: Installation
| 1. |
Installation is the reverse of removal.
|
| 2. |
Tighten the HECU mounting bolts and nuts to the specified torque.
|
| 3. |
After installation, bleed the brake system.
(Refer to ABS bleeding)
|
Removal
1.
Turn ignition switch OFF.
2.
Pull up the lock of the HECU connector (A), and then disconnect
the connector.
...
Front Wheel Speed
Sensor. Components and Components Location
Components
1. Front wheel speed sensor connector
2. Front wheel speed sensor
...
See also:
Operating door locks from inside the vehicle
With the door lock button
To unlock a door, push the door lock button (1) to the “Unlock” position.
The red mark (2) on the button will be visible.
To lock a door, push the door lock bu ...
Tightening Torque Table Of Standard Parts
Bolt nominal
diameter (mm)
Pitch (mm)
Torque Nm (kg.cm, lb.ft)
Head Mark 4
Head Mark 7
...
Inspection
1.
Disconnect the ignition switch connector (B) and key switch connector
(A) from under the steering column.
2.
Check for continui ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com