Hyundai Accent Manuals

Hyundai Accent: Removal - ESC Control Module. Repair procedures - ESC(Electronic Stability Control) System - Brake SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / ESC(Electronic Stability Control) System / ESC Control Module. Repair procedures / Removal

1.
Turn ignition switch OFF.
2.
Pull up the lock of the HECU connector (A), and then disconnect the connector.
3.
Remove the brake fluid from the master cylinder reservoir with a syringe.
•
Be sure to completely remove foreign substances from around brake fluid reservoir and cap before opening the reservoir cap. If not, it may cause contamination of brake fluid and deterioration in braking performance.
•
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
4.
Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner.
Tightening torque:
M11: 12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
M14: 18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

5.
Loosen the HECU bracket nuts (A), then remove HECU and bracket.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

•
Never attempt to disassemble the HECU.
•
The HECU must be transported and stored in.
•
Never shock to the HECU.
6.
Remove the 3 bolts, and then remove the bracket from HECU.
Tightening torque:
11 ~ 14 N.m (1.1 ~ 1.4 kgf.m, 8.1 ~ 10.3 lb-ft)

ESC Control Module. Repair procedures
...

Installation
1. Installation is the reverse of removal. 2. Tighten the HECU mounting bolts and nuts to the specified torque. 3. ...

See also:

Inspection
Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. ...

Injector. Description and Operation
Description Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is c ...

Measurement Method
Projected Dimensions 1. These are the dimensions measured when the measurement points are projected into the reference plane, and are the reference dimensions ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com