Hyundai Accent Manuals

Hyundai Accent: Installation - Variable Intake Solenoid (VIS) Valve. Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve. Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Use care to keep foreign material out of the valve.
1.
Installation is reverse of removal.

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ...

Fuel Pressure Control Valve. Description and Operation
Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on ...

See also:

Installation
1. Install the high mounted stop lamp. 2. Install the trunk trim. ...

Removal
1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Turn the steering wheel so that the ...

Rear Hub - Carrier. Components and Components Location
Components 1. Rear torsion beam assembly 2. Brake assembly 3. Rear wheel hub assembly 4. Rear brake disc 5. Rear brake disc mounting screw 6. Rear wheel / T ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com