Hyundai Accent Manuals

Hyundai Accent: Installation - SS-B Solenoid Valve(ON/OFF). Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / SS-B Solenoid Valve(ON/OFF). Repair procedures / Installation

1.
Installation is the reverse of removal.
•
The gasket of the valve body cover gasket (A) use new one.
•
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)

•
Perform TCM learning after replacing the automatic transaxle to prevent slow automatic transaxle response, jerky acceleration and jerky startup.
(Refer to "Automatic transaxle control system (Repair procedures)" in this group)

Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraul ...

Inhibitor Switch. Description and Operation
Description Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals. ...

See also:

Hands free mic. Repair procedures
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") ...

Tire rotation
To equalize tread wear, it is recommended that the tires be rotated every 7,500 miles (12,000 km) or sooner if irregular wear develops. During rotation, check the tires for correct balance. When r ...

Rear Torsion Beam Axle. Repair procedures
Replacement [Disc Type] 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com