Hyundai Accent: Power Door Mirror Actuator. Repair
proceduresInspection
| 1. |
Remove the front door quadrant delta cover.
(Refer to the BD group - "Front door")
|
| 2. |
Disconnect the power door mirror connector from the harness.
|
| 3. |
Apply battery voltage to each terminal as shown in the table and
verify that the mirror operates properly.
Side Repeater Lamp
Mirror Heater
|
Power Out Side Mirror Switch. Repair procedures
Power WindowsSS-B Solenoid Valve(ON/OFF). Schematic Diagrams
Circuit Diagram
...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is fo ...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk lower trim.
(Refer to the BD group - " Trunk Lid")
...