Hyundai Accent: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the trunk lower trim.
(Refer to the BD group - " Trunk Lid")
|
| 3. |
Disconnect the rear combination lamp connector (A). Remove the
rear combination lamp assembly (B) after loosening 3 nuts.
|
| 4. |
Remove the bulb after turning in the counterclockwise direction.
A : Tail Lamp / Stop Lamp
B : Turn Signal Lamp
C : Back Up Lamp
D : Side marker
|
| 5. |
If necessary to remove the bulb, remove the bulb after pulling
the trim cover aside.
[Tail Lamp / Stop Lamp]
[Turn Signal Lamp]
[Back up Lamp]
[Side marker]
|
Installation
1.
Install the rear combination lamp assembly.
2.
Connect the rear combination lamp assembly connector.
3.
Conn ...
See also:
Removal
Wiper and Washer Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper (A) and lower (B) shrouds aft ...
Input Speed Sensor. Specifications
Specifications
▷ Type: Hall effect sensor
Operation condition [°C(°F)]
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(1.2 ~ 1.8)
0.0472 ...
Manifold Absolute Pressure
Sensor (MAPS). Description and Operation
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density
type sensor and is installed on the surge tank. It senses absolute pressure
of the surge tank and transfers the analog ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com