Hyundai Accent: Removal
Disassembly of the thermostat would have an adverse
effect, causing a lowering of cooling efficiency.
|
| 1. |
Drain engine coolant so that its level would be under
the thermostat height.
|
| 2. |
Remove the radiator lower hose.
|
| 3. |
Remove the water inlet fitting (A) and thermostat
(B).
|
Inspection
1.
Immerse the thermostat in water and gradually heat
the water.
2.
Check the valve opening temperature.
...
See also:
Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located in the driver’s side panel bolster,
the other in the engine ...
Components Operations
PCM (Power Train Control Module)
1.
The PCM (ECM) (A) carries out a check of the ignition key using
a special encryption algorithm, which is programmed into the transp ...
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...
Hyundai Accent Manuals
© 2011-2022 Copyright www.hamanual.com