Hyundai Accent: Replacement
Tail Gate Trim Replacement
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Put on gloves to protect your hands.
|
|
1. |
After loosening the mounting screws, then remove the tail gate
trim (A).
|
2. |
Installation is the reverse of removal
• |
Replace any damaged clips.
|
|

|
Tail Gate Latch Replacement
1. |
Remove the tail gate trim.
|
2. |
Disconnect the tail gate latch rods (A).

|
3. |
After loosening the mounting bolts, then remove the latch assembly
(A).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
|

|
4. |
Disconnect the tail gate latch connector (A).

|
5. |
Installation is the reverse of removal
• |
Make sure the connector is connected properly
and the connecting rod is connected properly.
|
• |
Make sure the tail gate opens properly and locks
securely.
|
|
|
Key Holder Replacement
1. |
Remove the tail gate trim.
|
2. |
Disconnect the key holder rod (A), then loosen the key holder
(B) mounting bolts and remove.

|
3. |
Installation is the reverse of removal
|
Outside Handle Replacement
1. |
Remove the tail gate trim.
|
2. |
Disconnect the outside handle rod (A).

|
3. |
After loosening the mounting nuts, then remove the outside handle
(A).

|
4. |
Installation is the reverse of removal
|
Tail Gate Lift Replacement
•
|
Take care not to be closed the tail gate, when removing
the lift.
|
|
1. |
Using a screwdriver (A), lift up slightly the socket clips (B)
of both ends on the lifer (D), and then remove the lifter from the bracket
(C).

|
2. |
Push the socket of the lifter into the bracket for installation.
• |
Make sure the tail gate lock and opens properly
and locks securely.
|
|
|
Tail Gate weatherstrip Replacement
•
|
Do not apply sealant to the body.
|
|
1. |
Remove the tail gate weatherstrip (A).

|
2. |
Installation is the reverse of removal.
• |
Install the weatherstrip aligned with center line
(B).
|
|
|
1.
After loosening the tail gate hinge (A) mounting bolt, adjust
the tail gate by moving it up or down, or right or left.
2.
Adjust the tai ...
See also:
ESC OFF Switch. Repair
procedures
Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lower panel.
(Refer ...
Removal
Head Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper.
(Refer to the BD group - "Front bumper ...
Description and Operation
Description
The 6-spd automatic transaxle consists of an overdrive clutch (OD/C),
a one-way clutch (OWC), a low and reverse brake (LR/B), an underdrive brake
(UD/B), a 26 brake (26/B), and a ...