Hyundai Accent Manuals

Hyundai Accent: Replacement - Fluid. Repair procedures - Hydraulic System - Automatic Transaxle SystemHyundai Accent: Replacement

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Hydraulic System / Fluid. Repair procedures / Replacement

ATF of 6 speed automatic transaxle doesn’t need to be replaced. If the vehicle is used severely in business or personal use, replace ATF every 60,000 miles.
Severe usage is defined as
•
Driving in rough road (Bumpy, Gravel, Snowy, Unpaved road, etc)
•
Driving in mountain road, ascent/descent
•
Repetition of short distance driving
•
More than 50% operation in heavy city traffic during hot weather above 32°C(89.6°F) .
•
Police, Taxi, Commercial type operation or trailer towing, etc
1.
Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.

Drain plug tightening torque:
38.2 ~ 48.1 N.m (3.9 ~ 4.9 kgf.m, 28.2 ~ 35.4 lb-ft)
The gasket of the drain plug use new one.
2.
Fill the oil about 5 liters through eyebolt.
3.
Check the oil level.
(Refer to "Hydraulic system (Fluid)" in this group)

Service Adjustment Procedure
Oil level Check A check of ATF level is not normally required during scheduled services. If an oil leak is found, ...

Valve Body. Description and Operation
Description The valve body is essential to automatic transaxle control and consists of various valves used to control the oil feed from the oil pump. Specifically, these valves consist of pr ...

See also:

Installation
• Install the component with the specified torques. • ...

Installation
1. Installation is the reverse of removal. 2. Tighten the HECU mounting bolts and nuts to the specified torque. 3. ...

Inspection
1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com