Avoid braking or gear changing in corners, especially when roads are wet. Ideally, corners should always be taken under gentle acceleration. If you follow these suggestions, tire wear will be held to a minimum.
Dimensions Projected
1.
These are the dimensions measured when the measurement
points are projected from the vehicle's surface, and are the reference
dimensions used for used for body ...
Manual Transaxle. Components
and Components Location
Components
1. Transaxle support bracket
2. Control shaft complete
3. Back up lamp switch
4. Speedmeter
...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is fo ...