Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Washer Motor. Repair procedures / Removal

-	When servicing the washer pump, be careful not to damage the washer pump seal.

-	Do not operate the washer pump before filling the washer reservoir. Failure to do so could result in premature pump failure.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front bumper. (Refer to the BD group - "Front bumper")

3.	Remove the washer hose and disconnect the washer motor connector (A).

4.	Remove the washer reservoir (A) after removing 2 bolts.

Inspection

1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. ...

Installation

1. Install the washer reservoir. Before installing the pump motor, check the f ...

See also:

Seat Belt Buckle Switch (BS). Description and Operation
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status ...

Removal
1. Remove the transaxle assembly. (Refer to "Manual transaxle system" in MT group) 2. Remove the clutch cover bolts. Be careful ...

Purge Control Solenoid Valve (PCSV). Description and Operation
Description Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when ...

Hyundai Accent Manuals

© 2011-2024 Copyright www.hamanual.com