Inspection
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
3. |
Disconnect the connector from the power window switch module.
|
4. |
Check for continuity between the terminals in each switch position
according to the table.
|
Alternator. Components and Components
Location
Components
1. Nut
2. Pulley
3. Spacer
4. Front bracket
5. Front bearing
6. Stator
7. Rotor
8. Rear bearing
9. Rear bracket
10. Brush holder assem ...
Engine Coolant Temperature
Sensor (ECTS). Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
Repair procedures
On-vehicle Inspection
Spark Test
1.
Disconnect the connectors (A) and then ignition coils
(B).
2.
Disconnect ...