Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / ESC(Electronic Stability Control) System / Front Wheel Speed Sensor. Repair procedures / Removal

1.

Remove the front wheel and tire.

Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.

Remove the front wheel speed sensor mounting bolt (A).

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.8 lb-ft)

3.	Remove the front wheel guard.

4.	Remove the front wheel speed sensor cable mounting bolt.

5.	Disconnect the front wheel speed sensor connector, and then remove the front wheel speed sensor.

6.	Installation is the reverse of removal.

Front Wheel Speed Sensor. Repair procedures

...

Inspection

1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground. ...

See also:

Closing the tailgate
To close the tailgate, lower and push down the tailgate firmly. Make sure that the tailgate is securely latched. WARNING Make sure your hands, feet and other parts of your body are safely out o ...

Limitation of Active ECO operation
If the following conditions occur while Active ECO is operating, the system operation is limited even though there is no change in the ECO indicator. When the coolant temperature is low: The sys ...

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com