Hyundai Accent Manuals

Hyundai Accent: Inspection - Front Wheel Speed Sensor. Repair procedures - ESC(Electronic Stability Control) System - Brake SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Brake System / ESC(Electronic Stability Control) System / Front Wheel Speed Sensor. Repair procedures / Inspection

1.
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.
•
In order to protect the wheel speed sensor, when measuring output voltage, a 120 Ω resister must be used as shown.

2.
Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low: 0.7 V ~ 1.0 V
V_high: 1.4 V ~ 2.0 V
Frequency range: 1 ~ 2,500Hz

Removal
1. Remove the front wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Rear Wheel Speed Sensor. Components and Components Location
Components 1. Rear wheel speed sensor connector 2. Rear wheel speed sensor ...

See also:

Sunglass holder
To open the sunglass holder, press the cover and the holder will slowly open. Place your sunglasses in the compartment door with the lenses facing out. Push to close. WARNING Do not keep ob ...

Removal
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the ...

Inspection
1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com