Hyundai Accent Manuals

Hyundai Accent: Replacement - Trunk Lid. Repair procedures - Exterior - Body (Interior and Exterior)Hyundai Accent: Replacement

Trunk Lid Assembly Replacement
•
When removing and installing the trunk lid, an assistant is necessary.
•
Put on gloves to protect your hands.
1.
Detach the clips, then remove the trunk lid trim (A).

2.
Disconnect wiring (B) and connectors.
3.
After loosening the mounting bolts, then remove the trunk lid (A).

Tightening torque :
6.9 ~ 8.8 N.m (0.7 ~ 0.9 kgf.m, 5.1 ~ 6.5 lb-ft)

4.
Installation is the reverse of removal.
•
Replace any damaged clips.
Trunk Lid Latch Replacement
1.
Remove the trunk lid trim.
2.
Disconnect the trunk lid latch connector (A).
3.
Disconnect the cable (B), then loosen the latch assembly (C) mounting bolts and remove.

Tightening torque :
6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

4.
Installation is the reverse of removal.
•
Make sure the trunk lid locks/unlocks and opens/closes properly.
Trunk Lid Weatherstrip Replacement
1.
Remove the trunk lid weatherstrip (A).
•
Do not apply sealant to the body.

2.
Installation is the reverse of removal.
•
Install the weatherstrip aligned with canter line (B).

Trunk Lid. Repair procedures
...

Adjustment
1. After loosening the trunk lid hinge (A) mounting bolts, adjust the trunk lid by moving it up or down, or right or left. 2. Adjust the tr ...

See also:

Adjustment
Clutch Release Cylinder Air Bleeding Procedure Use the specified fluid. Avoid mixing different brands of fluid ...

Floor mat anchor
When using a floor mat on the front floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward. WARNING The floor mat must be ...

Inspection
1. Immerse the thermostat in water and gradually heat the water. 2. Check the valve opening temperature. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com