Hyundai Accent: Transmitter Code Registration (Using GDS)
Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Keyless Entry / Transmitter. Repair procedures / Transmitter Code Registration (Using GDS)
| 1. |
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
|
| 2. |
Select the vehicle model and then do "CODE SAVING"
|
| 3. |
After selecting "CODE SAVING" menu, button "ENTER" key, then the
screen will be shown as below.
|
| 4. |
After removing the ignition key from key cylinder, push "ENTER"
key to proceed to the next mode for code saving. Follow steps 1 to 4
and then code saving is completed.
|
Inspection
1.
Check that the red light flickers when the door lock or unlock
button is pressed on the transmitter.
2.
Remove the battery and check vol ...
See also:
Installation
1.
Install the BCM.
2.
Install the crash pad lower panel.
...
Glove box
To open the glove box, push the button and the glove box will automatically open.
Close the glove box after use.
WARNING
To reduce the risk of injury in an accident or sudden stop, always keep ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com